Fairbanks AN Series Fairbanks Access Solutions - Manual (Page 47)

Section 3: Access Terminal Screens Defined
01/13 47 51299 Rev. 1
3.2.10. Timeout And Delay Setup, Continued
Long Range RFID Tag Detection-These settings control how the system handles
detecting the same long range RFID tag just after a transaction was completed
successfully with that tag.
Ignore Last Long Range RFID Tag: Duration for which the system will ignore a long
range RFID tag that matches the long range RFID tag that was used on the last
transaction. This duration starts just after the transaction ends. See the timeline
below. For example, when a vehicle with an RFID tag completes a transaction, the
vehicle will start to drive off the scale. But while driving off, the RFID tag might still be
read by the reader. In this case, the ID should be ignored, because the vehicle just
completed its transaction. But if the vehicle remains on the scale for some time, that
may indicate that the driver wishes to start the transaction again. This setting will
determine the amount of time the system will ignore the same long range RFID tag
after the end of the transaction.
Prompt for Transaction Start: Duration for which the system will prompt the driver if
another transaction should be started. So if the last long range RFID tag is detected
again during this duration, the driver will have the option of starting a transaction.
This duration starts after the duration of ignoring the tag ends