Fairbanks AN Series Fairbanks Access Solutions - Manual (Page 88)

Section 3: Access Terminal Screens Defined
01/13 88 51299 Rev. 1
3.3.3. Network Setup
Primary IP Settings
•
DHCP: The system can be setup to use DHCP to get an IP address or
configured to use a static IP address that is provided by the network
administrator. Note that although DHCP works, there is no way to assign a
network host name to the terminal. So if the IP address changes it may be
difficult to find the terminal on the network.
•
IP Address: When DHCP is enable, the IP address assigned to the terminal
will be displayed. Otherwise enter the IP address that the terminal should use
on the network.
•
Subnet Mask: When DHCP is enabled, the subnet mask assigned to the
terminal will be displayed. Otherwise enter the subnet mask that the terminal
should use on the network.
•
Gateway: When DHCP is enabled, the default gateway assigned to the
terminal will be displayed. Otherwise enter the default gateway that the
terminal should use on the network.
A
C
B
A