Fairbanks AN Series Fairbanks Access Solutions - Manual (Page 79)

Section 3: Access Terminal Screens Defined
01/13 79 51299 Rev. 1
3.3.2. Input/Output Setup, Continued
•
Output Source: Select the input source that you want to configure from the
selection of configured tabs. The number of outputs will vary based on the IO
source.
•
Output Label: Enter a brief label. This will be displayed on the diagnostic
page and any drop-down lists for selecting outputs.
•
Assigned: Check this option if the output is assigned to an action. It is
recommended to check this setting whenever the output is being used. The
output should also be given a short label as well. Once “assigned”, then the
label will be used instead of just the generic “Output 1” in dropdown lists. This
output will be highlighted in the IO diagnostics as well.
•
Initially On: Enable this option if the output should be on when the system is
started.
IO Source tab selection
Output Setup C