Fairbanks AN Series Fairbanks Access Solutions - Manual (Page 66)

Section 3: Access Terminal Screens Defined
01/13 66 51299 Rev. 1
B
C
3.2.15. Weightment Setup, Continued
Tare Weight Options
Stored Tare Label: Set the text label to use for a tare weight that is stored with the
vehicle
Measured Tare Label: Set the text label to use for a tare weight that is measured or
read from the scale.
Entered Tare Label: Set the text label to use for a tare weight that is entered by the
driver.
New Tare Weight Difference Threshold: This threshold is used when a driver is
getting a new stored tare weight for a vehicle. If the new tare weight is within (+/-)
this threshold of the old stored tare weight no confirmation is needed. Otherwise if
the difference of the new and old weights is greater than this threshold, then the
driver must confirm the use of the new stored tare weight.
Enable Empty Prompt for Inbound vehicles: This setting enables the “Empty
Load” prompt. Basically this setting enables the ability for a driver to get a new
stored tare weight for the vehicle. This setting applies to only vehicles that use
stored tare weights and for vehicles that are marked as inbound vehicles in MatreX.
Enable Empty Prompt for Outbound vehicles: This setting is the same as above
but for only vehicles that are marked as outbound vehicles in MatreX.
Inbound and Outbound Overload Options
These two sections allow the terminal to check for and act on vehicles that weigh
more than their maximum gross weight. The maximum gross weight of the vehicle is
setup in MatreX on the Vehicle View/Edit page for each vehicle. The inbound and
outbound does not refer to the vehicle inbound/outbound flag. In this case it refers to
when the vehicle is arriving at the facility (inbound) or when the vehicle is leaving the
tacitly (outbound).
Check for overload: Enable this option to check for vehicles that are over their
maximum allowed weight. This maximum weight is assigned to each vehicle in
MatreX. There are separate but identical settings for vehicles that are entering
(inbound) or exiting (outbound) the facility.
Allow transaction: If enabled, the transaction will be allowed to complete. The driver
will still be warned and have the option to not complete the transaction.
Alarm on Overload: Sound Alarm