Traffic control setup, continued – Fairbanks AN Series Fairbanks Access Solutions User Manual
Page 56

Section 3: Access Terminal Screens Defined
01/13
56
51299 Rev. 1
3.2.11. Traffic Control Setup, Continued
Each one will have the following options:
Input & Latch Time: This is the input that will trigger
the alert. An optional latching time can be configured
on the input as well. A latching input will remain on
for the set duration after the actual input turns off.
Error/Warning Message: This message will be displayed to the driver on the screen.
The screen option in the general settings must be set to Instructional for these
messages to be displayed to the driver. This message will also be included in the
notification if email subscription is set to monitor Traffic Control Alerts.
Output & Duration: An output can be
turned on when an alert occurs. It can be
turned on for a set duration or for the entire
duration of the input including the latch
time.
Cancel transaction on traffic alert:
This option allows correction to bad staging of equipment and positioning of input
devices such as down range or sensitive long range reader equipment.
Example Site:
•
Radiation positioning was directly on the approach of the scale.
•
Long Range reader was positioned down range of scale to start transaction
•
Truck crept onto the scale slowly to verify tag reads.
•
Threshold weight was reached so Welcome Screen, appeared to allow start of
transaction.
•
Radiation detector completed scanning and found radiation but only after
transaction started. Checking this option will check after transaction starts as
well.