Fairbanks AN Series Fairbanks Access Solutions - Manual (Page 46)

Section 3: Access Terminal Screens Defined
01/13 46 51299 Rev. 1
3.2.10. Timeout And Delay Setup, Continued
Non-Input Screen Delays
•
Get Weight: Timeout for the get weight screen. Normally as soon as the
weight is read from the scale data, the system will advance to the next screen.
This timeout will only be used if there is an issue with the scale data. The most
often cause of delay is motion on the scale. There will be a message on the
screen when motion is detected. To speed this process up you can reduce the
required readings setting in the Scale Setup page on the Device Setup menu.
Confirm there is a motion status if the require readings is set to 1 (the default
is 3).
•
Display Weight: Timeout for the display weight screen. This timeout is only
used when displaying the weight not confirming the weight.
•
Print Ticket: Timeout for the printing scale ticket screen. This screen will
advance to the next state once printed is completed. A longer timeout is only a
safety net or for displaying an error.
•
Take Ticket: Timeout for the take scale ticket screen. This screen can be
skipped by setting the timeout to Off.
•
Pull Forward: This timeout only applies if the Traffic Control feature is not
enabled. If Traffic Control is enabled, this screen is displayed for as long as a
vehicle is detected on the scale (detected by weight and possibly sensors if
configured). View Pull Forward settings under Input/Output section (3.1.4.3)
for more information.
•
Cancel: Timeout value for ‘cancel’ screen
•
Take Refund: Timeout value for ‘take refund’ screen
•
Take Change: Timeout value for ‘take change’ screen