Darex XPS-16 Operating Instructions - Manual (Page 55)

55
Do not use sharpener until vacuum
system is connected to machine. The
airflow from the vacuum system
keeps the grinding wheel & motor cool
while running. Damage to the motor may
occur if vacuum is not running while sharp-
ening on the XPS-16.
XPS-16 VACUUM SYSTEM
The XPS-16 sharpener comes equipped with an
environmentally safe dust collection system. Hook
up the vacuum to your sharpener before sharpen-
ing drills.
HOW TO HOOK UP VACUUM
SYSTEM
1. Connect plug from vacuum to the receptacle
on the electrical panel located at the back of
the XPS-16 sharpener.
2. Connect Vacuum hose to the vacuum adapter
tube on the sharpener and to the intake tube
on the vacuum.
VACUUM SYSTEM DISASSEMBLY &
MAINTENANCE
1. Using a ¼ hex key wrench, remove bolt and
washer.
2. Remove top ½ cover of vacuum canister.
3. Remove and dispose of filter cartridge.
4. Unthread plastic nut retaining bottom ½ of
vacuum canister.
5. Remove bottom ½ of vacuum canister.
6. Clean out residual grinding dust from bottom
of canister.
To reassemble, reverse steps.
NOTE: When reassembling, make sure the
rim of the top ½ of vacuum canister is
seated into gasket channel on bottom ½ of
vacuum canister.
VACUUM SYSTEM AND
INSTALLATION INSTRUCTIONS
Vacuum System Information