Darex XPS-16 Operating Instructions - Manual (Page 102)

User Manual Page 7
Removing and Replacing the Chuck Locking Solenoid
Refer to the Chuck Spindle Drive Belt Replacement
instructions for cover and chuck removal and re-
assembly after solenoid change. See Section 24
Schematics and Work Instructions page 3.
1. Remove the cover and chuck. Disconnect both
connectors. Place the wires out of the way.
2. Unscrew the 2, 4mm screws that secure the
solenoid in place from the back of the housing.
Take a small flat blade screw driver and pull
the lock pin back and out of the locking hole.
Rotate the spindle cone so the pin remains out
of the locking hole.
3. Continue holding the pin back while gently
lifting the solenoid upward out of the recess
and tilting it to the bottom of the housing.
Once it is free remove it. To replace the
solenoid, rotate the spindle cone so the
locking hole is visible and in the center of the
solenoid mounting recess. Keep the solenoid
in straight alignment with the locking hole.
Hold the pin back and tuck it under and into
the locking hole and seat it in the recess.
Secure with the 2 screws and connect the
connectors. Tuck the connectors back into
place.
4. With the wires secured refer to the Chuck
Spindle Belt Drive Belt Replacement
instructions for reassembly of the chuck and
cover. See Section 24 Schematics and Work
Instructions page 3.
Solenoid
assembly
Solenoid
connectors
Sensor
connectors