Darex XPS-16 Operating Instructions - Manual (Page 17)

17
Steps to sharpening your
first drill on your CNC XPS-
16 Drill Sharpener.
Connect vacuum hoses and vacuum power cord to
sharpener. Refer to information on page 55
WARNING: DO NOT USE XPS-16 WITHOUT
VACUUM CONNECTED. IN ADDITION TO RE-
MOVING GRINDING PARTICLES, THE AIR
FLOW COOLS THE GRINDING MOTOR.
1. Plug in machine and
release emergency stop
button.
2. Located on the right
side of the machine is the
ON/OFF rocker switch. To
power up machine, push
rocker switch up.
3. Touch the on
the LCD Screen; the Self
Test Initialization program
will run. After initialization is
complete the Main Set Up
Screen will come up. Refer
to information on page 19
4. Insert a drill in chuck.
With the cutting edge ro-
tated in approximately the
12:30 to 1:00 position,
push in and hold the tip of
drill up against plunger,
while tightening chuck to
secure drill position. Do not
over tighten the chuck.
NOTE: The plunger or
stop is spring-loaded,
drill must push plunger
in all the way
5. Using the pictorial icon selections located on
the Main Set Up Screen choose your desired drill
point geometry. Refer to information on page 19
6. Close machine
door.
7. Press cycle start
Sharpening Your First Drill
Sharpening Your First Drill