Darex XPS-16 Operating Instructions - Manual (Page 54)

54
HONING BRUSH PART #’S
PP12686NF – Brush 120 Grit – Silicon Carbide
PP12680NF – Brush 180 Grit – Silicon Carbide
PP12684NF – Brush 320 Grit – Silicon Carbide
PP12688NF – Brush 240 Grit – Diamond
PP12682TF – Brush Retainer
PP12252FF – Bolts 3 each (4mm .7x18 SHCS)
SA12680NA – Brush, Retainer & Bolts
HOW TO CHANGE HONING
BRUSH
This can be done, leaving grinding wheel
mounted.
1. Push the emergency stop button, unplug unit
from power supply and use a “LOCK OUT”
“TAG OUT” procedure.
2. Using a 2.5mm hex key, remove the top two
3mm button head cap screws from wheel
guard cover.
3. Then, loosen, but do not remove the bottom
two 3mm button head cap screw s. pull wheel
guard cover away from wheel.
NOTE: Leave vacuum tube attached to
wheel guard cover
4. Using a 3mm hex key wrench, remove the three
4mm 7x18 SHCS .
5. Remove retainer ring.
6. Remove brush from wheel.
To reinstall, reverse steps.
Honing Information