PASCO SPARKvue ver.2.0 - Manual (Page 25)

1. Click the Sampling Options button.
The Sampling Options screen opens.
2. Click Periodic.
3. Click OK.
Putting SPARKvue into manual sampling mode
In manual sampling mode, a single value from each measurement is recorded each time
you manually trigger SPARKvue. Complete these steps to put SPARKvue into manual
sampling mode:
1. Click the Sampling Options button.
The Sampling Options screen opens.
2. Click Manual.
3. Click OK.
Setting an automatic stop condition
When a stop condition is set, SPARKvue automatically stops recording data after a set
time interval.
Complete these steps to set a stop condition:
1. Click the Sampling Options button.
The Sampling Options screen opens.
2. Under Automatic Stop Condition:, click the Condition: box and click Stop after
duration.
3. Click the Value box and enter a time value.
4. Click the Units box and click units of time.
5. Click OK.
Document Number: 012-11074D 13
SPARKvue
®
3 Setting up an experiment
Customizing data collection