PASCO SPARKvue ver.2.0 - Manual (Page 19)

The AirLink2 and SPARKlink Air can also connect via USB.
Note : If prompted, enter pass code "1234" for SPARKlink Air devices.
iPad
1. Use the standard iPad process to pair the PASCO bluetooth device.
2. Connect sensors as needed.
Android
1. Use the standard Android process to pair the PASCO bluetooth device.
2. Continue to step 1 of the Mac and Windows process.
Mac and Windows
To connect a device (no pairing necessary)
1. Turn on the AirLink2, SPARKlink Air or other supported bluetooth device.
2. Click the Device Tools button to open the Device Tools screen.
3. Click the Connect Sensor via Bluetooth button.
SPARKvue searches for available bluetooth sensors and lists the supported
devices within range.
Note : In a classroom setting, there may be many devices available for connection.
To ensure you are connecting with the correct PASCO device, check the back for
its identification number.
Note : If the device is not listed, pair the device using the standard Mac or Windows
process before continuing.
4. Click Connect.
The selected device will change from Connect to Disconnectupon successful
connection.
5. Click OK twice to close the Device Tools screen.
6. Optional: plug in sensors into the bluetooth interface.
To disconnect a device
Document Number: 012-11074D 7
SPARKvue
®
2 Starting an experiment
Connecting an interface and sensors to your computer