B&K Precision XLN60026 - Manual - Manual (Page 85)

78
Using Telnet
The power supply can be controlled via Telnet over the Ethernet interface.
Simply go into command prompt under MS-DOS and enter: Telnet
5024 ( is IP address of the unit; 5024 is the
Telnet port). A welcome message will be shown as below:
Input SCPI command to communicate with the system, such as below:
Using Sockets
All XLN series use port 5025 to provide the standard function for SCPI
socket. Users can use SCPI commands to control the supply through
their own program by using the standard SCPI socket.