B&K Precision XLN60026 - Manual - Manual (Page 163)

67
negative floating-point numeric values are some
examples of valid data.
Characters enclosed by single or double quotes
Line Feed, Hex code is 0x0Ah
Carriage Return, Hex code is 0x0Dh
End or identify
Note: All commands are terminated with and characters. A
space is always included in between the command and the parameter.
For example, to set the GPIB address of 10 to a power supply, the
following command is sent:
ADDR 10
Note: The and are not presented in the following examples and
command descriptions. However, users must add them as termination
characters at the end of each command when programming.
4.3
The Error/Event List
SCPI interface can offer an error/event list that contains up to 10 errors/events.
Users can read the errors/events through the “
error?” command in a first-in
first-out manner. Once an error/event is read, the read process will clear it from
the memory. To clear all errors/events from the memory, the “
*CLS” command
is used.
Error Description
-000 No error
-001 Command error
-002 Execution error
-003 Query error
-004 Input Range error