Alpha Technologies PowerAgent SC3 - Manual (Page 4)

PowerAgent TM SC3 Site Controller Document # 700-000014-01 Rev 2
Installation and Operation
Phoenix Broadband Technologies, LLC 10/28/2010
Page 4 of 57
1 Important Information
1.1 Revision History
Release Date Revision Description
Rev 1 04/27/2010 Draft for review, Firmware version 4.04, Web version 1.1
Rev 2 05/12/2010 On going revisions, Firmware version 4.10, Web version 1.3
1.2 Safety Notes
High currents and voltages may be present on the equipment terminals and on the
interior of the equipment. Make sure you understand and observe all appropriate
safety codes and regulations. Follow prudent electrical safety practices when
installing or servicing the equipment. Installation, maintenance and servicing of
the equipment should only be performed by qualified, trained and authorized
personnel.
Before installation, take measurements with a Volt Meter to ensure that no jar post in the
system has lethal AC or DC voltages relative to earth ground.
Except as explained in this manual, there are no user-serviceable parts inside the
PowerAgent Battery Monitoring System components. Opening the equipment could
expose you to dangerous voltages and void the product warranty. All product servicing
should be referred to factory-authorized personnel.
Use only interconnection cables supplied or authorized by Phoenix Broadband
Technologies. Use of user-made interconnection cable assemblies could result in
damage to equipment and potential safety hazards and voiding of equipment warranties.
Do not exceed the voltage specifications of the product.
Make sure the equipment is grounded properly.
The equipment should be protected from liquids, moisture, explosive, and corrosive
vapors.