Alpha Technologies PowerAgent SC3 - Manual (Page 22)

PowerAgent TM SC3 Site Controller Document # 700-000014-01 Rev 2
Installation and Operation
Phoenix Broadband Technologies, LLC 10/28/2010
Page 22 of 57
5.9 Site Controller Setup Menu
No matter what method of access was used the Setup Menu will then be displayed as shown
below. These screen shots were made with a telnet client but they will look the same in a serial
program.
The top two thirds of the screen
displays the present
configuration. The menu at the
bottom of the screen displays
the setup menu.
Closing the telnet window
will terminate the telnet
session and reset the Site
Controller. To avoid resetting
the Site Controller exit by
pressing “8” followed by “Enter”.