Alpha Technologies PowerAgent SC3 - Manual (Page 15)

PowerAgent TM SC3 Site Controller Document # 700-000014-01 Rev 2
Installation and Operation
Phoenix Broadband Technologies, LLC 10/28/2010
Page 15 of 57
7. Connect last sensor in the daisy chain to one of the six controller’s sensor input ports
8. View the router’s web page to determine which IP address has been given to the
controller (write it down)
9. Type the IP address of the controller into your laptop’s web browser and verify that the
web page displays properly. Verify that all sensors have been auto-discovered. Verify
that the parameter information displayed in the web page appears reasonable
10. Verify telnet connectivity by connecting to the controller via telnet (remember Phoenix
Broadband uses port 9999 for our telnet connection)
11. If you are using an SNMP manager, verify proper SNMP operation (gets, sets & traps)
This bench evaluation can also be performed using the free Lookout software described in the
SNMP section of this manual.