Extron Electronics TLP 710TV User Guide - Manual (Page 38)

4. Click OK . The Project Settings dialog box closes and is replaced by the Add Device
dialog box:
Figure 35. Global Configurator Add Device Dialog Box
5. Add a device to your project as follows:
a. To see all the options, click the Advanced >>> button. The button name changes
to Basic <<< (as shown in the figure above).
b. Select the IP Link device from the drop-down menu. In figure 36, above, an
IPL 250 controller is added. Adding a different IP Link product is similar.
c. Enter the IP address of the IP Link controller. The default value is
192.168.254.254, but this may have been changed. Check with your IT
department to verify the address.
d. Enter a display name into the text box. This is what the device will be known as in
the Global Configurator project.
e. Checking the Make this device a GlobalViewer Host check box is optional.
f. Set the Telnet port (usually 23) and the web port (usually 80).
g. If the controller is password protected, enter the password into the Admin
Password or User Password field.
h. In the right pane, set up a GlobalViewer tree. For information about this, see the
Global Configurator help file.
TLP 710MV and TLP 710TV • Configuration Software 32