Extron Electronics TLP 710TV User Guide - Manual (Page 45)

Mounting with a Swivel Mount Adapter
The TLP 710TV can be mounted with the optional Extron SMA-1 swivel mount adapter.
This allows the unit to be mounted permanently yet swivel up to 180° in either direction.
1. Remove the back cover and base cover, using the provided Extron removal tool, as
described in “
Removing the TLP 710TV Base for VESA Mounting “ on the next
page.
2. Remove the screw holding the locking plate at the bottom of the base. This releases
the weight, which can be removed from the top of the base, leaving the mounting
hole that will fit over the conduit of the SMA-1.
Locking Screw Locking Plate
Figure 44. TLP 710TV Base, Showing Locking Plate and Screw
3. Attach the conduit, insulation disk, and swivel disk and configure the set screws to
allow for the degree of swivel that is required (see the SMA-1 Swivel Mount Adapter
Kit User Guide, available at
www.extron.com ).
4. Place the mounting hole in the base over the conduit of the SMA-1.
5. Secure the unit with the backing plate and locking nut as described in the SMA-1
Swivel Mount Adapter Kit User Guide.
Removing the TLP 710TV Base for VESA Mounting
Notch to Remove
Base Cover
Notch to Remove
Back Cover
Figure 45. Removing the Back and Base Covers
1. Remove the back cover by inserting the Extron removal tool (provided) into the
notches on each side and prying off the cover.
2. Remove the base cover using the Extron removal tool.
TLP 710MV and TLP 710TV • Mounting 39