Checking advanced settings – YSI 600DW-B Sonde User Manual
Page 31
Sondes
Section
2
For parameters with multiple unit options such as temperature, conductivity, specific conductance,
resistivity and TDS, a submenu will appear as shown below for temperature, allowing selection of desired
units for this parameter.
--------------Select units-------------
1-(*)NONE
2-( )Temp C
3-( )Temp F
4-( )Temp K
Select option (0 for previous menu): 2
After configuring your display with the desired parameters, press
Esc or 0 to return to the Main menu.
CHECKING ADVANCED SETTINGS
Select
Advanced from the Main menu. The following menu will be displayed.
----------------Advanced--------------
1-Cal constants
2-Setup
3-Sensor
4-Data filter
Select option (0 for previous menu):
Select
Setup from the Advanced menu.
-------------Advanced setup-----------
1-(*)VT100 emulation
2-( )Power up to Menu
3-( )Power up to Run
4-( )Comma radix
5-(*)Auto sleep RS232
6-(*)Auto sleep SDI12
7-( )Multi SDI12
8-( )Full SDI12
Select option (0 for previous menu): 0
Make sure that, other than
Auto sleep RS232, all entries are activated or deactivated as shown above.
For sondes which will be used in sampling studies where the user is present and observes readings in real-
time,
Auto sleep RS232 should usually be “off’. For sondes that will be used in unattended monitoring
YSI Incorporated
Drinking Water Monitoring Systems Operations Manual
2-24