YSI 600DW-B Sonde - Manual (Page 26)

Sondes Section 2
For PC-based sonde interface, run EcoWatch for Windows and click on the sonde icon, from the
toolbar Then select the proper Com port and confirm by clicking OK. A window similar to that shown
below will appear indicating connection to the sonde as shown in the figure below. Type “ Menu” after the
# sign, press Enter, and the sonde Main menu will be displayed.
If your sonde has previously been used, the
Main menu (rather than the # sign) may appear when
communication is established. In this case simply proceed as described below. You will not be required to
type “
Menu”.
If you are unable to establish interaction with the sonde, make sure that the cable is properly connected. If
you are using external power, make certain that the YSI 6038 or 6651 power supply or other 12 vdc source
is properly working. Recheck the setup of the Com port and other software parameters. Also refer to
Section 6, Troubleshooting.
The sonde software is menu-driven. You select functions by typing their corresponding numbers. You do
not need to press
Enter after choosing a selection. Type the 0 or Esc key to return to the previous menu.
YSI Incorporated Drinking Water Monitoring Systems Operations Manual 2-19