Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1579 - Manual (Page 57)

Assembly
45 PNEG-720-G2 12" & 16" Series II Sweep
A. Center Pivot With Pivot Kit
1. Use the pivot assembly supplied with the sweep pivot kit and cut it to fit, if needed.
2. Feed the multi-conductor cord through the hole in the back of the sweep head section leaving
five feet (5') of cord outside the hole.
The center pipe of the pivot assembly MUST be in the center of the bin. If it
is not, the sweep could hit the bin wall.
If you are only running the cords across the floor, you may skip step 17A and go
to step 17B.
multi-conductor cord
(Leave 5' of cord out-
side of hole.)
FIG. 17-A2
17. CENTER PIVOT INSTALLATION