Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1579 - Manual (Page 25)

Assembly
25 PNEG-720-G2 12" & 16" Series II Sweep
Bearing
90°
Grease
Zerk
FIG. 6-B
The gear reducer is NOT filled with oil from the factory. For gear reducer
specifications and oil fill recommendations, refer to the lubrication section of
this manual.
6. DRIVE AXLE ASSEMBLY & BEARING SUPPORT
5. GEAR REDUCER ASSEMBLY (CONT.)
The input shaft of the reducer MUST be to
the top of the reducer. Refer to the owner's
manual supplied with the reducer for proper
vent plug, fill plug, and drain plug locations.
FIG. 5
FIG. 6-C
gear reducer
hex bolt
hex nut
flat washers
lock nut
hex bolt
input
shaft
A. Loosen set screws on bearings.
B. Replace standard grease zerks with 90°
grease zerks on both bearings. Make sure
the 90° grease zerk is turned as shown in Fig.
6-B, so the zerks are accessible from the
center of the tractor drive stand.
C. Slide the axle assembly between the legs of
the tractor drive stand as shown in Fig 6-C.
Axle Assembly
Tractor Drive
Stand Legs
Bearings