Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1579 - Manual (Page 16)

16 12" & 16" Series II Sweep PNEG-720-G2
General Product Information
1. PRODUCT INFORMATION
A. The Series 2 Sweep includes the following components:
- control panel
- two (2) motors
- motor covers
- motor mount
- auger flighting
- auger backshield assembly
- jack supports
B. The unit will operate only in a round grain bin equipped with a center sump in the bin floor.
2. GENERAL INFORMATION.
A. GSI reserves the right to improve its product whenever possible and practical to do so. We reserve
the right to change, improve and modify products at any time without obligation to make changes,
improvements and modifications on equipment sold previously.
B. This new bin sweep auger has been engineered and manufactured to give years of dependable
service. The care and maintenance of this equipment will affect the satisfaction and service ob-
tained. By following the instructions and suggestions recommended, the owner should receive
quality service for many years. If additional information or assistance should be required, please
contact GSI.
C. It is important to check both the quantity of parts and their descriptions with the packing list enclosed
within each package. All claims for freight damage or shortage must be made by the consignee
within ten (10) days from the date of the occurrence of freight damage. The consignee should
accept the shipment after noting the damage or loss.
NEVER enter a grain bin unless ALL power driven equipment has been shut down.
Disconnect and lockout power before entering the bin or servicing the equipment.
Attention! This Series 2 Sweep is a single pass sweep. Consult the manufacturer of
your storage tank regarding the requirements or restrictions of the sweeping process.
The manufacturer may require a multiple pass sweep.