Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1579 - Manual (Page 24)

24 12" & 16" Series II Sweep PNEG-720-G2
Assembly
4. FLANGE BEARING ASSEMBLY
A. Slide the flange bearing onto the end stub and bolt it to the end plate using hex bolts, lockwashers,
and hex nuts.
12" Sweep 2" Flange Bearing
Four (4) 1/2"-13 x 2-1/2" Hex Bolts
16" Sweep 3" Flange Bearing
Four (4) 3/4"-10 x 3-1/2" Hex Bolts
Do not tighten the set screws on the bearing at this time. This can be done after
the gear reducer is installed.
5. GEAR REDUCER ASSEMBLY
A. Slide the output shaft of the reducer through the end plate of the head section and into the end of
the head flight and secure it the shafts with hex bolts and lock nuts. (See Figure 5)
12" Two (2) 5/8"-11 x 3-1/2" Hex Bolts
16" Two (2) 3/4"-10 x 5-1/2" Hex Bolts
B. Bolt the reducer to the end plate of the head section using hex bolts, flat washers, & lockwashers,
supplied with the reducer. (See Figure 5)
12" Four (4) 5/8"-11 x 2-1/2" Hex Bolts
16" Four (4) 3/4"-10 x 2-3/4" Hex Bolts
hex bolt
lockwasher
hex nut
flange bearing
Caster assembly only used on all 16" sweeps & 12" sweeps with
extensions.
FIG. 4
(16" Shown.)