beautypg.com

Assembly – Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1579 User Manual

Page 31

background image

Assembly

PNEG-1579 12" & 16" Series II Sweep Special

29-B

9. GUARD ASSEMBLY - (CONT.)

FIG. TD5

Reducer not shown in this view. Removed for
Illustrational Purposes Only.

Slide Seal on Reducer Shaft
Before Installing Sprocket

Attach the Dust Seal Clips
with3/8 Hex Nuts

E.

Slide the Dust Seal Clips over the studs welded to the Guard Plate, capturing the Upper Shaft Seal.

F.

Lock the Dust Seal Clips into position by tightening the 3/8 hex nuts.

G.

Attach the Inner Bottom Drive Shaft Seal (GC11974) to the Guard Plate using 3/8-16 x 1 1/4" bolts, hex

nuts and flat washers. This seal is designed to fit tight around the Drive Axle Shaft. (See Figure TD6)