Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1579 - Manual (Page 43)

Assembly
35 PNEG-720-G2 12" & 16" Series II Sweep
Warning! To ensure that the drive is not unexpectedly started, turn off and
lock out or tag out the power source before proceeding. Failure to observe
these precautions could result in bodily injury.
C. Loosely bolt the bushing and small sheave together with the screws provided with the bushing.
D. Slide the bushing and small sheave onto the motor shaft with a key. (See Fig. 14-B)
bushing
small sheave
output shaft
key
FIG. 14-A
FIG. 14-B
14. SHEAVE INSTALLATION
bushing
large sheave
input shaft
key
A. Loosely bolt the bushing and large sheave together with the screws provided with the bushing.
B. Slide the bushing and large sheave onto the auger gear reducer input shaft with a key. (See Fig. 14-A)
Wedging forces in the bushing saw
slot, such as that exerted by a
narrow edged regular screw driver,
may damage or break the bushing.
This damage would not be covered
under the GSI warranty.