Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1579 - Manual (Page 45)

Assembly
PNEG-1579 12" & 16" Series II Sweep Special
14. SHEAVE INSTALLATION (cont.)
H. Attach the bottom belt guard assembly to the motor mount frame with 3/8-16 x 1 HHCS, 3/8 flat
washers and 3/8 lock washers. Do not tighten the 3/8 HHCS as the assembly will be adjusted after
the top cover is attached.
Sheave, bushing
and belts not
shown for clarity
Loosely attach the
bottom belt guard
assembly to the
motor mount frame
with 3/8"-16 x 1
HHCS, 3/8" flat
washers and 3/8"
lock washers
Do not tighten these
bolts until the belt
guard top assembly
is mounted.
FIG. 14H
36-A
I. Attach both the bottom belt guard seals (GC12026 an GC12027) around the reducer shaft and to the
bottom belt guard assembly using 3/8-16 x 1 HHCS, 3/8 flat washers and 3/8 lock washers.
FIG. 14I
Attach both belt guard
bottom seals to the bottom
belt guard assembly
Attach using 3/8"-16 x 1"
HHCS, 3/8" flat washers
and 3/8" lock washers