Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1579 - Manual (Page 55)

Assembly
43 PNEG-720-G2 12" & 16" Series II Sweep
16. JACK SUPPORT ASSEMBLY
A. Attach one (1) caster wheel to the jack caster
assembly using one (1) 3/4" x 5-1/2" hex bolt,
lockwasher, and hex nut.
B. Locate the 2" x 2" x 12" tube to the right of each
connecting angle and fasten the jack mount
assembly to the sweep frame using one (1) jack
mount plate, four (4) 1/2"-13 x 3-3/4" hex bolts,
lockwashers, and hex nuts.
C. Attach the jack caster assembly to the jack
assembly using one (1) pin.
D. Bolt the jack assembly to the jack mount as-
sembly using four (4) 1/2"-13 x 2" hex bolts,
lockwashers, and hex nuts.
1/2" x 2"
hex bolt
jack
assembly
1/2" x 3-3/4"
hex bolt
jack mount
assembly
jack mount
plate
Tubes cut away
for clarity.
3/8" x 2 3/4"
safety snap pin
Connecting
Angle
FIG. 16-C
B. Locate the 2" x 2" x 12" tube to the right of each
connecting angle and fasten the jack mount
assembly to the sweep frame using one (1) jack
mount plate, four (4) 1/2"-13 x 3-3/4" hex bolts,
lockwashers, and hex nuts.
C. Attached 16" Jack Caster Assembly to the
swivel caster wheel using four (4) 1/2" x 1-1/2"
HHCS bolts, lockwashers, & hex nuts.
D. Attach the jack caster assembly to the jack
assembly using one (1) pin.
E. Bolt the jack assembly to the jack mount as-
sembly using four (4) 1/2"-13 x 2" hex bolts,
lockwashers, and hex nuts.
All Current Production and Old Style 12"
Jack Support (See fig. 16-A & 16-C)
All Old Style 16" Jack Support (See fig.
16A & 16-C)
A. Attach one (1) caster wheel to the jack caster
assembly using one (1) 3/4" x 5-1/2" hex bolt,
lockwasher, and hex nut.
Be sure to use the spanner bushings, supplied with the caster wheels, between the
caster and the caster plate on each side. (12" Sweeps Only.)
CURRENT PRODUCTION SWEEP SHOWN