Ohaus GT Series Electronic Balance - Manual (Page 97)

58
MENUS
Date (Cont.) Date (Cont.) Date (Cont.) Date (Cont.) Date (Cont.)
10. to change flashing digit.
11. .
12. to change year.
13. .
14. .
15. .
NOTE NOTE NOTE NOTE NOTE: At power up, if Time in the GLP submenu is set to ON, the display flashes
for about 1.5 seconds to prompt setting of time and date .
Lockswitch Lockswitch Lockswitch Lockswitch Lockswitch
Lockswitch enables you to lock out one or more menu selections. Each menu can be
individually locked on or off
after all functions have been set after all functions have been set after all functions have been set after all functions have been set after all functions have been set . The Calibration Calibration Calibration Calibration Calibration,
User, Setup User, Setup User, Setup User, Setup User, Setup and Print Print Print Print Print menus can be individually locked on or off by selecting the
appropriate menu and then locked by the switch located under the front of the control
panel. See Menu Lockout Section. Cal Test under Calibration remains functional with
the Lockswitch On or Off. Before performing the lockout procedure, decide which
functions of the balance are to be locked on or off.
1. Access the submenu which is under the Setup menu.
2. to access either Calibration, User, Setup or Print menus.
3. to access selected desired menu.
4. to select or .
YES = locked, NO = not locked. YES = locked, NO = not locked. YES = locked, NO = not locked. YES = locked, NO = not locked. YES = locked, NO = not locked.
5. to accept.
6. to change to other menus.
7. To change other menus, repeat steps 2 through 5.