Animal weighing, Operation – Ohaus GT Series Electronic Balance User Manual

Page 63

OPERATION

Animal Weighing

Animal Weighing is

enabled only

when Animal Weighing Function is selected under

the Setup menu. Refer to page 46. To set options, refer to page 55, Animal Weighing
Options under the Setup Options submenu.

With the balance in a weighing mode, proceed as follows:

(Animal Weighing Container).

2. Place the container on the platform.

NOTE

NOTE:

to return to weighing mode.

. The container weight is tared.

4. Place the subject in the container. The balance indicates a countdown to

. This cycle accommodates for movement.

The balance then displays the actual weight of the subject with flashing unit

indicator and returns to

after approximately six sec-

onds. Repeat steps 1 through 4 for another subject or

to start

another weighing cycle.

NOTE

NOTE: If Auto Print is enabled, the display returns to ready in approximately one

second.

to return to weighing mode while display shows

NOTE

NOTE:

while the same subject is on the balance will cause Animal Weighing

to start over.

Check Weighing (Cont.)

13. Repeat steps 10 and 11 to set the over value. When the last digit is entered,

the display indicates one of three display modes for check weighing.

14. Check weighing can now be performed by removing a sample and placing a

new sample on the platform.

15.

allows other weighing units to be displayed if previously

selected.