Ohaus GT Series Electronic Balance - Manual (Page 46)

7
INTRODUCTION
INTRODUCTION INTRODUCTION INTRODUCTION INTRODUCTION INTRODUCTION
This manual covers Installation, Operation and Troubleshooting for the Ohaus
Precision Advanced Series of Electronic balances, Models GT210, GT400, GT410,
GT2100, GT4000, GT4100, and GT8000. Suffixes after the basic model number are:
D = Moveable FineRange
TM , T=Tower Mount and V=Non Type Approved. Models with
an E suffix = Type Approved with CE conformance and bear official markings (Max,
Min, Class, etc.) on a serial number plate located on the side of the balance. To ensure
proper operation of the balance, please read this manual completely.
DESCRIPTION DESCRIPTION DESCRIPTION DESCRIPTION DESCRIPTION
The Ohaus Precision Advanced GT Series balances are precision weighing instru-
ments, designed to be versatile, accurate, easy to operate and will provide years of
service with virtually no maintenance. The Precision Advanced series is constructed
using a die-cast aluminum base finished with a durable corrosion resistant epoxy
powder paint. It contains solid-state precision electronics PC boards, and a seven and
a half, 0.45 inch digit, Vacuum Fluorescent display. Each balance operates through
a series of menus which enhances operation. A built in lockswitch prevents preset
settings from being changed. To prevent measurements from being affected by air
currents, a Draft Shield is mounted to the balance and is standard with Models GT210,
GT410 and GT410D.
FEATURES
Precision Advanced balances contain four main display menus which enable you to
calibrate and configure the balance for specific operating requirements.
• MENU MENU MENU MENU MENU When switch is pressed and released with MENU displayed, allows
entry into other menus.
• CALIBRATION CALIBRATION CALIBRATION CALIBRATION CALIBRATION Menu - Allows the balance to be calibrated by using either Span
or Linearity calibration methods. A Test function is used to verify the last
calibration.
• USER USER USER USER USER Menu - Allows the balance to be set for environmental conditions. Reset,
averaging level, stability range, auto-zero and beep (sound) functions can be set.
• SETUP SETUP SETUP SETUP SETUP Menu - Allows the balance to be customized for specific weighing
functions.
• PRINT PRINT PRINT PRINT PRINT Menu - Allows the selection of parameters under which the balance will
interface to a computer or a printer.
Each of these menus contain selectable parameters which can be entered via the front
panel switches. Storing of the parameters is accomplished by selecting
End End End End End at the
completion of all selections in a particular menu. For a detailed description of each
feature, refer to the individual menus in this manual.