Ohaus GT Series Electronic Balance - Manual (Page 106)

67
MENUS
Reference Reference Reference Reference Reference
When the Reference function is set ON, prints the value of weight used as a reference
in either Check Weighing, Fill Guide, Percent and Parts Counting modes. When set
to Current, the printer prints the current reference immedediately.
1. Access the submenu under the Print Options menu
2. .
3. , or
.
4. .
Date Date Date Date Date
When the Date function is set ON, allows the balance to output the current date to
the printer. To set the Date feature ON or OFF, proceed as follows:
1. Access the submenu under the Print Options menu
2. .
3. or .
4. .
NOTE NOTE NOTE NOTE NOTE: With Print Time or Date set to ON, if either current Time or Date has not been
set in Setup menu, "Set Time/Date !" is sent through the RS232 Interface with each
press of button.
Difference Difference Difference Difference Difference
Difference data is only output to the printer when Check Weighing or Fill Guide TM mode
was selected.
1. Access the submenu under the Print Options menu
2. .
3. or .
4. .