Check weighing, Operation – Ohaus GT Series Electronic Balance User Manual

Page 62

OPERATION

Check Weighing

Check Weighing is

enabled only

when the Check Weighing Function is selected in

the Setup menu. Refer to page 46. Refer to page 52, Check Weighing Options under
the Setup menu to set the Reference Type and Display Type options. In the check
weighing mode, a reference weight can be set into the balance either as a reference
weight on the pan or as a user entered number. The balance display shows either
under, accept or over as each sample is weighed.

If reference weight

reference weight

reference weight was selected under CW Options submenu:

1. With the balance in the weighing mode,

NOTE

NOTE: If reference number

reference number

reference number was selected, go to step 7.

2. Place a sample weight on the pan which is considered to be the under limit

for check weighing.

4. Place a sample weight on the pan which is considered to be the over weight

limit for check weighing.

. The display blanks until a stable reading is achieved, then it goes

to either the (Normal, None or Sign) display type previously selected in CW
Options submenu to indicate under, over or acceptacle limits of the objects
being weighed.

6. Check weighing can now be made by removing a sample and placing a new

sample on the pan.

If reference number

reference number

reference number was selected under the CW Options submenu:

7. With the balance in the weighing mode,

to return to weighing .

indicates under value with first digit flashing.

10.

until the first digit (under weight) is correctly displayed.

11.

to accept the value.

12. Repeat steps 10 and 11and set all digits to the desired value. When the last

digit is entered, display changes to an over value to be entered with the

first digit flashing

NOTE

NOTE:

allows going back.