Stability range, Auto-zero, Menus – Ohaus GT Series Electronic Balance User Manual

Page 80

MENUS

Stability Range

The stability range specifies the weighing results must be within a preset tolerance limit
for a certain time to turn the stability indicator ON. When a displayed weight changes
beyond the allowable range, the stability indicator turns OFF, indicating an unstable
condition. Factory default setting is shown in bold type.

Stb .5 d

Stb .5 d Smallest range: stability indicator is ON only

Smallest range: stability indicator is ON only

Smallest range: stability indicator is ON only
when displayed weight is within .5 divisions.

when displayed weight is within .5 divisions.

Stb 1 d Reduced range.
Stb 2 d Normal range.
Stb 5 d Largest range: stability indicator is ON even though

displayed weight changes slightly.

When the RS232 interface is configured to print stable data only, the stability range also
governs data output. Displayed data will only be output if it is within the selected stability
range.
To view or change the stability range:

1. Access the Stability Range

submenu.

to select

through

Auto-Zero

Auto-Zero minimizes the effects of temperature changes and shift on the zero reading.
The balance maintains the zero display until the threshold is exceeded. Factory default
setting is shown in bold type.

OFF

Turns Auto-Zero OFF.

.5 d

Sets threshold to .5 divisions.

1 d

Sets threshold to 1 division.

3 d

Sets threshold to 3 divisions.

To view or change the auto-zero setting:

1. Access the Auto-Zero

submenu.

to select

through