Ohaus GT Series Electronic Balance - Manual (Page 76)

37
MENUS
Span Calibration Span Calibration Span Calibration Span Calibration Span Calibration
1. .
2. .
3. , = no mass should be on the platform.
4. = mass which
must be placed on the platform.
5. allows the selection of either 25%, 50%, 75%, or 100% of full
span to be used to calibrate the balance. Example shows value of 50% for a
4 kg balance.
6. Place required mass on the platform , .
. When mass is displayed with current unit indicator,
and the stability indicator (S) is ON, the balance is recalibrated.
7. Remove the mass from the platform . Span
calibration is complete. The balance is now in a weighing mode.
NOTE: NOTE: NOTE: NOTE: NOTE: Do not disturb the balance Do not disturb the balance Do not disturb the balance Do not disturb the balance Do not disturb the balance
when -C- is displayed. when -C- is displayed. when -C- is displayed. when -C- is displayed. when -C- is displayed.
Linearity Calibration Linearity Calibration Linearity Calibration Linearity Calibration Linearity Calibration
1. .
2. .
3. .
4. , = no mass should be on the platform.
5. = mass which
must be placed on the platform.
6. Place the required mass on the platform,
= next mass to be placed on the platform.
7. Place the required mass on the platform, .
. When mass is displayed with current unit indicator
and the stability indicator (S) is ON, the balance is recalibrated.
8. Remove the mass from the platform . Linearity
calibration is complete. The balance is now in a weighing mode.
NOTE: NOTE: NOTE: NOTE: NOTE: Do not disturb the balance Do not disturb the balance Do not disturb the balance Do not disturb the balance Do not disturb the balance
when -C- is displayed. when -C- is displayed. when -C- is displayed. when -C- is displayed. when -C- is displayed.