Ohaus GT Series Electronic Balance - Manual (Page 51)

12
INSTALLATION
Command Command Command Command Command
Character Character Character Character Character Description Description Description Description Description
? ? ? ? ? Print current mode
nnnA nnnA nnnA nnnA nnnA Set Auto Print feature to “nnn”
(see table).
C C C C C Begin span calibration
xD xD xD xD xD Set 1 second print delay (set x = 0 for OFF, or x = 1 for ON)
E E E E E Exit parts counting or percent weighing
x x x x x IIIII Set Averaging Level to “x”,
where x = 0 to 3 (see table).
L L L L L Begin linearity calibration
M M M M M Same effect as pressing mode button
xM xM xM xM xM Places balance in mode “x”,
where x = 1 to 13 (see table).
If unit or mode is not already
enabled, command will be ignored.
RS232 COMMAND TABLE RS232 COMMAND TABLE RS232 COMMAND TABLE RS232 COMMAND TABLE RS232 COMMAND TABLE
Field: Mode Stab CR LF
Length: 5 1 1 1
blank if stable
“ ? ” if unstable
1 = grams
2 = pennyweight
3 = carats
4 = avoidupois ounces
5 = troy ounces
6 = grains
7 = taels
8 = momme
9 = pounds
10 = pounds:ounces
11 = custom unit
12 = parts counting
13 = percent weighing
nnn = 0 Turns feature OFF
nnn = S Output on stability
nnn = C Output is continuous
nnn = 1-256 Sets Auto Print
Interval
0 = minimum level
1 =
2 =
3 = maximum level
Grams
Pennyweight
Carats
Avoidupois ounces
Troy ounces
Grains
Taels Momme
Pounds
Pounds:ounces
Custom unit
Parts counting
Percent weighing
Error