Ohaus GT Series Electronic Balance - Manual (Page 81)

42
MENUS
GT BEEPS GT BEEPS GT BEEPS GT BEEPS GT BEEPS
Power-On Single long beep (Plug in, not front panel On) Single long beep *
Key Press Single short beep
Auto-Tare occurrence Double short beep *
FillGuide TM 100% (first time after no load) Triple short beep
Check Weigh Accept First time after no load) Triple short beep
High Point - new high or low value detected Double short beep
End of Animal Weigh cycle Double short beep
Reset in Menu Double short beep *
* Indicates that the beep cannot be disabled.
Exiting User Menu Exiting User Menu Exiting User Menu Exiting User Menu Exiting User Menu
To exit the User menu and store settings, proceed as follows:
1. Access End Usr submenu.
2. .
3. .
4. .
Beep Function Beep Function Beep Function Beep Function Beep Function
A beep (sound) feature is a tone or series of tones emitted to annunciate various
balance conditions. The table below defines when the beeps are sounded if turned
ON. The default setting for the Beep menu is OFF. To turn the sound feature ON,
proceed as follows:
1. Access the Beep submenu.
2. .
3. to select or .
4. .