Ohaus MB45 MOISTURE ANALYZER Manual - Manual (Page 60)

58 MB45
10.1 Cleaning Interior/Exterior Components (cont)
Cleaning Temperature Sensor and Protective Glass
Check the protective glass and the temperature sensor for debris
which could impede the operation. If the glass appears dirty,
clean the surface facing the compartment using a commercial
glass cleaner. If the sensor is dirty, clean using a mild cleaning
agent.
Removing Glass for Cleaning
If the inside of the glass is dirty, open the cover and remove the
four cover screws as shown.
Remove the glass holder and glass from the cover and clean
with a commercial glass cleaner on both sides.
Reassemble after cleaning.
Cleaning air inlet
The air inlet of the fan is located at the rear of the instrument and
its exterior should be cleaned from time to time to free it from any
dust deposits.