Ohaus MB45 MOISTURE ANALYZER Manual - Manual (Page 17)

MB45 15
3. Making a simple measurement (cont)
-DEFAULT-
100°C / 10:00
1.000 G
0.000
*
GRAMS
TEST ID:
TEMP/TIME:
TARG. WGT:
SAMPLE
<.500G
Wet the specimen sample with a 0.5 to 1 gram of water.
NOTE: Minimum sample size must be greater than 0.5 gram.
-DEFAULT-
100°C / 10:00
1.000 G
0.930
*
GRAMS
TEST ID:
TEMP/TIME:
TARG. WGT:
CLOSE
COVER
Close the cover.
Starting the test
Press the Start/Stop button. The Moisture Analyzer starts the
drying and measurement process.
TEST ID:
TEMP/TIME:
INITIAL WT:
-DEFAULT-
100°C / 10:00
0.930 GRAMS
08:11
70 C 4.04
*
%MOISTURE
Drying and measurement
You are now able to follow the progress of the drying cycle on the
display. This first display comes up automatically when the test
was started.
Observing the test progress
There are six displays available when the Moisture Analyzer is running a test. The Display button on the
front panel when pressed repeatedly accesses each of the six displays during the run mode of the
Analyzer and cycles though each display in the order shown below.
The displays indicate the Test ID, Temperature/Time, Initial Weight, actual temperature, elapsed time
duration of the test, either moisture, solids, grams, percent regain, a graph representing the actual test
progress and statistics at the end of the test.