Ohaus MB45 MOISTURE ANALYZER Manual - Manual (Page 14)

12 MB45
2.4 Leveling the Moisture Analyzer
Exact horizontal positioning and stable installation are prerequisites for repeatable results. To
compensate for small irregularities or inclinations at the location, the instrument can be leveled.
Adjust the leveling feet at the rear of the Moisture Analyzer
until the air bubble in the indicator is centered. The level
indicator is located under the cover towards the rear of
the Moisture Analyzer.
NOTE: The instrument should be leveled each time its
location is changed.
2.5 Connecting to a Power Supply
Check to ensure the voltage identification label on the Moisture Analyzer matches
your local line voltage. If this is not the case, do not connect the Moisture Analyzer to
the power supply, contact your responsible OHAUS dealer.
The halogen dryer unit is designed to operate at a specific line voltage
(120 V ac or 240 V ac). The dryer unit is installed at the factory and is matched to
the particular line voltage of the country of destination.
Connection to a line voltage that is too high can lead to burning out the halogen
heater, whereas, a supply voltage that is too low will prolong the drying process and
the instrument may not operate properly.
Leveling
Indicator
Leveling
Foot