Ohaus MB45 MOISTURE ANALYZER Manual - Manual (Page 19)

MB45 17
4. The menus
4.1 What are the menus?
There are two sets of menus used in the Moisture Analyzer. One is the Setup menu which is activated by
the Setup button. This menu permits calibration, adding custom units, language selection, beeper
volume settings, time and date format, communication settings and print criteria. The Test menu is
activated by the Test Menu button. This menu permits setting up new test parameters which includes test
temperatures, ID, profiling, timed information, type of display, print intervals, editing and running the test.
A test library is also included which holds data for up to 50 tests which can be recalled and run at any
time. The contents of each menu are shown below.
SETUP TEST MENU
Test Library
⎯ Edit Test
⎯ Lockout
⎯ Weight Calibration
⎯ Temperature Calibration
⎯ Language
English, Deutsch, Español, Francais,
Italiano
⎯ Beeper
− Low, High, Off
⎯ Time-Date
− Date Format, Set Date
− Time Format, Set Time
⎯ RS232
− Baud Rate
1200, 2400, 4800, 9600, 19,200
− Parity
Odd, Even, None
− Data Bits
7, 8
− Stop Bits
1, 2
− Handshake
None, XON-XOFF, RTS-CTS
⎯ Print
− Print On/Off
− GLP On/Off
⎯ Display
− Contrast
− Brightness
⎯ Factory Reset
⎯ 01
⎯ Load Test
⎯ Edit Test
⎯ Delete Test
⎯ 02
⎯ Load Test
⎯ Edit Test
⎯ Delete Test
⎯ 03
⎯ Load Test
⎯ Edit Test
⎯ Delete Test
y
y
y
⎯ 50
⎯ Load Test
⎯ Edit Test
⎯ Delete Test
⎯ Test Parameters
⎯ Test ID:
⎯ Profile:
− Standard
− Fast
− Ramp
− Step
⎯ Dry Temp:
⎯ Switch Off:
− Timed-Switch Off
− Man.-Use Start/Stop
− AFREE – Wt
loss/time
− A90 - < 1MG in 90 sec.
− A60 - < 1MG in 60 sec.
− A30 - < 1MG in 30 sec.
⎯ Result:
− % Moisture
− Custom Units
− Grams
− % Regain
− % Solids
⎯ Custom
− Factor, Exponent, LSD
⎯ Target Wt:
⎯ Print Int:
− Off, 1, 3, 5, 10, 30
Sec
− 1, 2, 5 Min.
⎯ Save Test: