Ohaus MB45 MOISTURE ANALYZER Manual - Manual (Page 18)

16 MB45
Observing the test progress (cont)
Press the Display button repeatedly to view the progress of the sample test with different displays.
The test automatically stops at the end of 10:00 minutes. If you want to end the test sooner, press the
START/STOP button.
Press
Display
Ö
TEST ID:
TEMP/TIME:
INITIAL WT:
-DEFAULT-
100°C / 10:00
0.930 GRAMS
08:11
0.00
*
%SOLIDS
100 C
Press
Display
Ö
Press
×
Display
Press
Ø
Display
Press
Display
Õ
Press
Display
Õ
Congratulations! You have just performed your first measurement with your
moisture analyzer.
Carefully remove the sample pan handler from the drying area.
Warning: As the pan and sample may still be hot, you should let these cool
down before removing the pan from the pan handler!
To remove the sample pan from the pan handler, lift the pan slightly from
below and pull it sideways out of the pan handler (if you no longer need the
sample and pan, you can simply tilt the pan handler until the pan slides out).
The last display from the test remains on the screen until you press the Tare
button. Press the Tare button. This sets the Moisture Analyzer to zero.
The display returns to the first test display, ready to repeat the test.
If you want to get out of the test mode, simply press any other button on the unit.
Continue to review the rest of this manual and become familiar with the menus.