ZyXEL Communications GS-4012 - Manual (Page 390)

Chapter 47 Configuration Mode Commands
GS-4012F/4024 User’s Guide
390
47.6 Static Route Commands
You can create and configure static routes on the Switch by using the ip route command.
Syntax:
ip route
ip route [metric ][name ]
--> [inactive]
where
An example is shown next.
• Create a static route with the destination IP address of 172.21.1.104, subnet mask of
255.255.0.0 and the gateway IP address of 192.168.1.2.
• Assigns a metric value of 2 to the static route.
• Assigns the name “route1” to the static route.
47.7 Enabling MAC Filtering
You can create a filter to drop packets based on the MAC address of the source or the
destination.
Syntax:
mac-filter name mac vlan drop
= Specifies the network IP address of the final destination.
= Specifies the subnet mask of this destination.
= Specifies the IP address of the gateway. The gateway is an
immediate neighbor of your Switch that will forward the
packet to the destination. The gateway must be a router on
the same segment as your Switch.
[metric ] = The metric represents the “cost” of transmission for routing
purposes. IP routing uses hop count as the measurement of
cost, with a minimum of 1 for directly connected networks.
Enter a number that approximates the cost for this link. The
number need not be precise, but it must be between 1 and
15. In practice, 2 or 3 is usually a good number.
[name ] = Specifies a descriptive name (up to 32 printable ASCII
characters) for identification purposes.
[inactive] = Deactivates a static route
sysname(config)# ip route 172.21.1.104 255.255.0.0 192.168.1.2
sysname(config)# ip route 172.21.1.104 255.255.0.0 192.168.1.2 metric 2
sysname(config)# ip route 172.21.1.104 255.255.0.0 192.168.1.2 name route1