ZyXEL Communications GS-4012 - Manual (Page 361)

Chapter 45 Introducing Commands
GS-4012F/4024 User’s Guide
361
igmp Enables and enters the IGMP
configuration mode.
13
exit Leaves the IGMP configuration
mode.
13
non-querier Sets the Switch to Non-Querier
mode. (If a multicast router with a
lower IP address, it will stop
sending Query messages on that
network.)
13
no non-querier Disables non-querier mode on
the Switch, (a multicast router
always sends Query messages).
13
unknown-
multicast-frame
Specifies the action the Switch
should perform when it receives
unknown multicast frames.
13
ospf Enables and enters the OSPF
configuration mode.
13
area Enables and sets the area ID. 13
area
authentication Enables simple authentication for
the area.
13
area
authentication
message-digest Enables MD5 authentication for
the area.
13
area
default-cost
<0-16777214> Sets the cost to the area. 13
area
name Sets a descriptive name for the
area for identification purposes.
13
area
stub Enables and sets the area as a
stub area.
13
area
stub no-summary Sets the stub area not to send
any LSA (Link State
Advertisement).
13
area
virtual-link
Sets the virtual link ID
information for the area.
13
area
virtual-link
authentication-
key Enables simple authentication
and sets the authentication key
for the specified virtual link in the
area.
13
area
virtual-link
authentication-
same-as-area Sets the virtual link to use the
same authentication method as
the area.
13
Table 139 Command Summary: Configuration Mode (continued)
COMMAND DESCRIPTION PRIVILEGE