Configuration mode commands, 1 change the out of band management ip address, 2 enabling igmp snooping – ZyXEL Communications GS-4012 User Manual
Page 383: Chapter 47 configuration mode commands, Configuration mode commands (383)
GS-4012F/4024 User’s Guide
383
C
H A P T E R
47
Configuration Mode Commands
This chapter describes how to enable and configure your Switch’s features using commands.
For more background information, see the feature specific chapters which proceed the
commands chapters.
47.1 Change the Out of Band Management IP Address
Use the
ip address
command to change the IP address of the out of band management port
on the Switch.
Syntax:
ip address
An example is shown next.
• Change the out of band Management IP address to 192.168.0.2
• View updated settings.
See example in
for information on how to change the in band
management IP address for the Switch.
47.2 Enabling IGMP Snooping
To enable IGMP snooping on the Switch. Enter
igmp-snooping
and press [ENTER]. You
can also set how to treat traffic from an unknown multicast group by typing the
unknown-
multicast-frame
parameter.
sysname(config)# ip address 192.168.0.2 255.255.255.0
sysname(config)# exit
sysname# show ip
Management IP Address
IP[192.168.0.2], Netmask[255.255.255.0], VID[0]
IP Interface
IP[192.168.2.1], Netmask[255.255.255.0], VID[2]