ZyXEL Communications GS-4012 - Manual (Page 333)

Chapter 45 Introducing Commands
GS-4012F/4024 User’s Guide
333
45.12.1 User Mode
The following table describes the commands available for User mode.
Table 137 Command Summary: User Mode
COMMAND DESCRIPTION
PRIVILEG
E
help Displays help information. 0
logout Exits from the CLI. 0
exit Logs out from the CLI. 0
history Displays a list of previously command(s) that you
have executed. The Switch stores up to 256
commands in history.
0
enable Accesses Enable (or privileged) mode. See
Section 45.12.2 on page 334 . Enable the highest
privilege level for executing commands.
0
<0-14> Accesses Enable mode commands up to the
privilege level specified. See Section 45.12.2 on
page 334 .
0
Accesses Enable (or privileged) mode. See
Section 45.12.2 on page 334 .
0
show ip Displays IP related information. 0
hardware-monitor Displays current hardware monitor information with
the specified temperature unit (Celsius C or
Fahrenheit F).
0
system-information Displays general system information. 0
alarm-status Display which alarms are enabled on the Switch as
well as the LED status of the alarms.
0
cpu-utilization Display statistics about the utilization of the CPU
on the Switch.
0
version flash Display the version of the currently installed
firmware on the flash memory.
0
version Display the version of the currently running
firmware on the Switch.
0
ping Sends Ping request to an Ethernet device. 0
[vlan
]
[size <0-1472>]
[-t] Sends Ping request to an Ethernet device in the
specified VLAN(s) with the specified parameters.
0
help Displays command help information. 0
traceroute Determines the path a packet takes to a device. 0
[vlan ]
[ttl <1-255>]
[wait <1-60>]
[queries <1-10>] Determines the path a packet takes to a device in a
VLAN.
0
help Displays command help information. 0
ssh <1|2> <[user@]dest-ip> Connects to an SSH server with the specified SSH
version.
0