ZyXEL Communications GS-4012 - Manual (Page 373)

Chapter 45 Introducing Commands
GS-4012F/4024 User’s Guide
373
45.12.5 interface route-domain Commands
The following table lists the interface route-domain commands in configuration mode.
Use these commands to configure the IP routing domains.
vlan-stacking priority <0-7> Sets the priority of the specified
port(s) in VLAN stacking.
13
role tunnel> Sets the VLAN stacking port roles
of the specified port(s).
13
SPVID Sets the service provider VID of
the specified port(s).
13
vlan-trunking Enables VLAN Trunking on ports
connected to other switches or
routers (but not ports directly
connected to end users) to allow
frames belonging to unknown
VLAN groups to pass through the
Switch.
13
weight
... A weight value of one to eight is
given to each variable from wt 1 to
wt 8.
13
wrr Sets the port(s) to use Weighted
Round Robin queuing.
13
Table 140 interface port-channel Commands (continued)
COMMAND DESCRIPTION PRIVILEGE
Table 141 interface route-domain Commands
COMMAND DESCRIPTION PRIVILEGE
interface
route-domain
/
Enables a routing domain for
configuration.
13
exit Exits from the interface routing-
domain command mode.
13
ip dvmrp Enables this function to permit
VLAN groups beyond the local
Switch.
13
igmp Enables IGMP in this routing
domain and specifies the version
of the IGMP packets that the
Switch should use.
13
igmp robustness-
variable <2-255> Sets the igmp robustness
variable on the Switch. This
variable specifies how
susceptible the subnet is to lost
packets.
13
igmp query-interval Sets the igmp query interval on
the Switch. This variable
specifies the amount of time in
seconds between general query
messages sent by the router.
13