ZyXEL Communications GS-4012 - Manual (Page 368)

Chapter 45 Introducing Commands
GS-4012F/4024 User’s Guide
368
45.12.4 interface port-channel Commands
The following table lists the interface port-channel commands in configuration mode.
Use these commands to configure the ports.
Sets the SP TPID (Service
Provider Tag Protocol Identifier).
13
vlan-type <802.1q|port-
based>
Specifies the VLAN type. 13
Table 139 Command Summary: Configuration Mode (continued)
COMMAND DESCRIPTION PRIVILEGE
Table 140 interface port-channel Commands
COMMAND DESCRIPTION PRIVILEGE
interface
port-
channel
list> Enables a port or a list of ports for
configuration.
13
arp inspection trust Sets the port to be a trusted port
for arp inspection. The Switch
does not discard ARP packets on
trusted ports for any reason.
13
limit rate Specifies the maximum rate (1-
2048 packets per second) at
which the Switch receives ARP
packets from each port. The
Switch discards any additional
ARP packets. Enter 0 to disable
this limit.
13
limit rate
burst interval
Specifies the length (1-15
seconds) of the burst interval.
The burst interval is the length of
time over which the rate of ARP
packets is monitored for each
port.
13
bandwidth-limit Enables ingress (pir), cir and
egress limits on the port(s).
13
cir Enables the guaranteed
bandwidth limits for incoming
traffic on the port(s).
13
cir Sets the guaranteed bandwidth
allowed for incoming traffic on the
port(s).
13
pir Enables bandwidth limits allowed
for incoming traffic on the port(s).
13
pir Sets the maximum bandwidth
allowed for incoming traffic on the
port(s).
13
egress Enables bandwidth limits allowed
for outgoing traffic on the port(s).
13