Introducing the web configurator, 1 web configurator overview, 2 accessing the web configurator – ZyXEL Communications NBG420N User Manual
Page 37: Chapter 3 introducing the web configurator, Introducing the web configurator (37)
NBG420N User’s Guide
37
C
H A P T E R
3
Introducing the Web
Configurator
This chapter describes how to access the NBG420N web configurator and provides an
overview of its screens.
3.1 Web Configurator Overview
The web configurator is an HTML-based management interface that allows easy setup and
management of the NBG420N via Internet browser. Use Internet Explorer 6.0 and later or
Netscape Navigator 7.0 and later versions or Safari 2.0 or later versions. The recommended
screen resolution is 1024 by 768 pixels.
In order to use the web configurator you need to allow:
• Web browser pop-up windows from your device. Web pop-up blocking is enabled by
default in Windows XP SP (Service Pack) 2.
• JavaScripts (enabled by default).
• Java permissions (enabled by default).
Refer to the Troubleshooting chapter to see how to make sure these functions are allowed in
Internet Explorer.
3.2 Accessing the Web Configurator
1 Make sure your NBG420N hardware is properly connected and prepare your computer
or computer network to connect to the NBG420N (refer to the Quick Start Guide).
2 Launch your web browser.
3 Type "http://192.168.1.1" as the website address.
Your computer must be in the same subnet in order to access this website address.
• In Router Mode enable the DHCP Server. The NBG420N assigns your computer an IP
address on the same subnet.
• In AP Mode the NBG420N does not assign an IP address to your computer, so you should
check it’s in the same subnet. See
for more information.